hp smart array p410i controller support hdd 500gb

Download, compile, and install cciss_vol_status which is found here: (look for cciss_vol_status-1.12.tar.gz).

Since you lose out on some of the automatic SMART drive monitoring, you'll have to do this manually through the use of cciss_vol_status and smartctl.

This makes life a lot easier in the event of a drive failure. You will want to disconnect/remove one drive at a time and see what device goes offline, this way you can label your drives on your chassis/enclosure. If you attempt to view the hard disk serial from the web UI, you'll see the same serial number for all your drives because this is coming from the RAID controller.

This will give you a list of device names and gptid.

After creating your first vdev and before loading any data in it, run a 'zpool status' and copy the outputs.

As I stated in the preface, the HP SAs don't support JBOD mode, so you need to put each drive in its own RAID0 logical volume.

Originally, the older controllers did not support drives over 2TB but the new firmware does.

Update your HP SmartArray (SA) controller to start with.

Here are some of the things I've done to mitigate potential issues. I know that you lose out on a lot of features by running each drive in an individual RAID0 logical volume. Keep in mind that this is for my home and the data isn't mission critical. Preface: Old HP server hardware is cheap! I have over 75TB of data and not much extra cash to drum up a proper solution. Type “help” for a list of supported commands.Here is my experience with HP SmartArray controllers with FreeNAS. Sample result: HP Smart Storage Administrator CLI 3.10.3.0

Now you have the tools needed for the job! so run the utility. echo -e 'deb stretch/current non-free' > /etc/apt//hpe.list curl | apt-key add -Īdd the HP repo (be sure to change the stretch to whatever your release is). However as its laid out, best of luck getting up and running quickly if you follow that page. The official HP software page for the information below is here. We need to install the HP provided software for it. Now we know we have a HP machine, Proliant DL180 G6 to be exact in this case, and the exact rev of the card itself. Subsystem: Hewlett-Packard Company Smart Array P410 Sample result: 06:00.0 RAID bus controller: Hewlett-Packard Company Smart Array G6 controllers (rev 01) Second we check lspci to see what controller we have installed. dmidecode | grep -A3 '^System Information' There is a chance of serious data loss if you don’t follow common sense practices and MAKE BACKUPS.įirst we check who makes this system. Take note, that you may have a different controller from this one by a different manufacturer, or it may require a different version of the software tool from HP, please check on the HP site linked below before continuing on. If you have the HP Smart Array Raid Controller as you will see in just a bit, this article is for you.

Hp smart array p410i controller support hdd 500gb